Home » Simplify your calculations with ease. » Industrial » Offset Conduit Calculator Online

Offset Conduit Calculator Online

Show Your Love:

The offset conduit calculator is designed to simplify the calculations needed for bending conduits accurately. By inputting a few necessary measurements, the calculator provides the precise bending angles and measurements required, ensuring that the conduits fit perfectly in their designated spaces without any guesswork.

Formula of Offset Conduit Calculator

To understand how the offset conduit calculator works, it’s essential to comprehend the formula it uses:

Offset = (Tangent of Bend Angle) × (Conduit Multiplier) × (Distance Between Bends)

See also  Alloy Density Calculator

Here’s a closer look at each component:

  • Tangent of Bend Angle: This is the tangent (tan) of the angle at which you need to bend the conduit.
  • Distance Between Bends: This is the linear distance between the two points where the bends will occur.
  • Conduit Multiplier: These are fixed values predetermined based on the type and size of the conduit. Here are some typical values:
    • ½ inch EMT: 5
    • ¾ inch EMT: 6.5
    • 1 inch EMT: 8
    • And so on up to 2 inch EMT: 15

Table for General Terms

To further aid in your conduit bending projects, here is a quick-reference table with common terms and pre-calculated values for typical scenarios:

See also  Bend Force Calculator
Conduit SizeBend AngleDistance Between BendsOffset Calculation
½ inch EMT30°24 inches60 inches
¾ inch EMT45°36 inches156.5 inches
1 inch EMT90°48 inches384 inches
(Note: These values are illustrative and should be adjusted based on actual project requirements.)

Example of Offset Conduit Calculator

Let’s go through a practical example. Suppose you need to bend a ¾ inch EMT conduit with a 30° bend angle, and the distance between bends is 24 inches. Using the formula:

  • Offset = Tan(30°) × 6.5 × 24 = 45.15 inches

Most Common FAQs

Q2: How do I determine the correct bend angle for my project?

A: Calculate the angle based on the spatial requirements of the installation site or use an angle finder tool.

Q3: Can the offset conduit calculator be use for all types of conduits?

A: While it’s optimize for EMT, it can be adapt for other types of conduits by adjusting the multiplier values accordingly.

Leave a Comment